Features:
1. Dual-antenna, DSSS and FHSS dual spread spectrum anti-interference technology was adopted.
2. Suitable for 9 channel transmitter AT9, AT9S and 10 channel transmitter AT10, AT10II.
3. PWM signal output working mode: red LED indicates PWM signal output, 11 channels totally.
4. S-BUS signal output working mode: blue/purple LED indicates S-BUS and PWM signal working at the same time. S-BUS signal channel( 3 pin of row 11 ) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used (eg: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).
5. Integrated signal strength, voltage data return and RSSI values. Support extended engine voltage telemetry module PRM-01 and module PRM-02 can feedback GPS info, speed, voltage etc.

Specifications:   
Channels: 12CH
Working Voltage: 4.8-10V
Working Current: 38-45mA（input voltage: 5V）
Size: 50 * 31.5 * 14.5mm / 1.97 * 1.24 * 0.57inch
Weight: 17g
Section Precision: 4096, 0.25us per section
Control Distance: about 4km 
Type: Receiver

Match code:
Each transmitter has its own ID code. The receiver must be matched code with the transmitter before starting to use. After code is matched, the ID code is stored in the receiver and there is no need to re-match.

How to match code with transmitter:
Put the transmitter and the receiver close to each other within 1m.
Turn on the transmitter, then the receiver will search for the nearest transmitter to match code.
Press the (ID SET) switch on the side of the receiver for more than 1 second and the LED flashes to indicate the start of matching code.
Stopping flashing means completion of matching code.
Please confirm that the servo can operate according to the transmitter.
  
Installation of the receiver antenna:
The antenna must be kept as straight as possible, or it will reduce the effective range.
Large model aircraft may has some metal part interfering signal; in this case the antennas should be placed at both sides of the model. Then the best RF signal condition is obtained at any flying attitude.
The antennas must be kept away from metal conductors and carbon fiber at least a half inch, but can not be over bent.
Keep the antennas away from the motor, ESC, and other noise sources as far as possible, and antennas can be packed by sponge or foam for shockproof when it is installed to the model.

Package Include:
1 x Receiver

Warning:
After all of the above steps were finished, turn off the transmitter and then power it on, now the program functions to assure it under control of transmitter with a right connection.