DSO138 Digital Oscilloscope Kit With Scope Probe Multipurpose DIY Oscilloscope Easy Operation American Standard Power Supply

Features:
1. This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as ARM test development board.
2. Can be secondary development on the basis of this kit, such as it can be changed to Millivoltmeter, data loggers.
3. Adjustable vertical displacement, and with instructions.
With automatic, regular modes, easy to capture the moments waveform.
4. Available rising or falling edge trigger.
5. Observable previous trigger waveform (negative delay).
6. Can freezing at any time waveform display (HOLD function).
7. Comes 1Hz /3.3V square wave test signal source.
8. With waveform parameter digital display, including frequency, period, pulse width, duty ratio, MAX./MIN./AVG./virtual values.
9. Waveform storage function: will not lose the waveform after power off.
10. Short-circuit and open-circuit detection: can help the user find out the soldering error.
11. TFT controller recognition function. 
 
Notice:
1.Actual color may be slightly different from the image due to different monitor and light effect
2.Please allow 1-3cm deviation due to manual measurement
              
Description:
Maximum Real-time Sampling Rate: 1Msps
Accuracy: 12Bit
Sampling Buffer Depth: 1024 bytes
Analog Bandwidth: 0-200KHz
Vertical Sensitivity: 10mV / Div - 5V / Div (1-2-5 progressive manner)
Input Impedance: 1MΩ
Maximum Input Voltage: 50Vpp (1: 1 probe), 400Vpp (10: 1 probe)
Coupling Modes: DC / AC / GND
The Horizontal Time Base Range: 10μs / Div - 50s / Div (1-2-5 progressive manner)
Supply Voltage: DC 9V
PCB Size: 117 * 76mm / 4.6 * 3 inch
Screen Size: 52 * 40mm / 2 * 1.57 inch
Note: This DIY kit is not soldered yet!

Package List:
1 x DSO138 Digital Oscilloscope
or
1 x Power Supply (US Plug, EU Plug optional)
or
1 x P6100 Probe