حرك مؤشر الماوس فوق الصورة للتكبير

الماركة:

عام

GT-24 Digital Wireless Transmission Module Industrial Grade 2.4G NRF24L01+PA+LNA ModulePaste Mounting

د.إ 39.5450% خصم
د.إ19.77
لكل قطعةشامل ضريبة القيمة المضافة
نقبل
الدفع عند الاستلام
التحويل المصرفي
حد ائتمان

معلومات عن هذا المنتج

Support 51 STM8S STM32 and other microcontroller development boards.

The module is nRF24L01P + PA + LNA and its driving method is exactly the same as nRF24L01P. Users can operate according to the nRF24L01P chip manual.

The CE pin is connected to the LNA enable pin. When CE = 1, the LNA is turned on. When CE = 0, the LNA is turned off. This operation is identical to the transmit and receive modes of the nRF24L01. In other words, the user does not need to care about the operation of the LNA at all.

The CE can be connected high for a long time, but the module must first be set to the POWER DOWN power-down mode when writing to the register. It is recommended to connect the CE to the IO port of the MCU. The IRQ can be disconnected and the interrupt status can be obtained using the SPI polling mode. However, it is recommended to use an external interrupt from the microcontroller.

The module's CE pin timing operation can reach the 10us mentioned in the nRF24L01P technical manual, but we recommend changing it to: SPI operation until CE goes high until the transmit interrupt is completed, then keep 1ms high time, then Lower the CE. The purpose is to switch to receive mode immediately after sending the GT-24. If CE = 0, the LNA is turned off, which will adversely affect the receiving sensitivity.

كمية (قطعة)

الحد الأدنى لكمية الطلب هو 1 قطعة

الحد الأدنى للطلب:1 قطعة

الشحن والإرجاع

طلبات الإرجاع
سياسة الإرجاع الخاصة بالبائع اعرف المزيد
سيتم عرض السعر النهائي وتواريخ التوصيل وخيارات الشحن الإضافية عند إتمام عملية الشراء والدفع.

معلومات عن البائع

معتمد

الصين

المزيد من هذا البائع

نظرة عامة

معرف وحدة إدارة المخزون للبائع:
TRE11010190082712D214-14683-24199
ورقة المواصفات الفنية متوفرة حسب الطلب
لا
Dangerous goods
No
Item height
1
Item length
8
Item weight unit
g
Item width
6
Item dimensions unit
cm
Item weight
2

وصف المنتج

Item Type:Wireless Module
Type:Direct Insert/Patch Mounting(Optional)

Serial number product name parameter Summary
1 model GT-24 ————
2 RF solution nRF24L01P ————
3 Module size 30.3 x 14.5mm / 1.19 x 0.57in   PCB antenna included
4 Working frequency 2.4GHz-2.525GHz Adjustable, 1MHz step
5 Production Process Lead-free environmentally friendly process Machine stickers, products must be machine-mounted to ensure consistent batch reliability
6 Interface mode 1*8*1.27mm/2*4*2.54mm The patch can also be used with the universal board and line.
7 Supply voltage DC: 2.0-3.6V Note: Voltages above 3.6V will cause permanent damage to the module.
8 Communication level 0.7VCC-3.3V VCC refers to the module supply voltage
9 Measured distance 1000m Clear and empty, maximum power, height 2m, 250K air speed
10 Transmit power 4 levels adjustable up to 20dBm About 100mW at maximum power
11 Air speed 250K-2Mbps Level 3 adjustable (250Kbps, 1Mbps, 2Mbps)
12 Shutdown current About 30uA Test conditions: CE=0, power down mode, VCC=3.0V
13 Emission current About 90mA Power supply capacity must be greater than 250mA
14 Receiving current About 20mA CE=1
15 Antenna form PCB antenna / ipex carrier antenna ————
16 Communication Interface SPI High speed power up to 10Mbps
17 Launch length Single packet 1-32 bytes 3-level FIFO
18 Receiving length Single packet 1-32 bytes 3-level FIFO
19 RSSI support not support Only simple packet loss statistics are supported
20 Receiving sensitivity -B2294dBm@250Kbp ————
21 Operating temperature -40~+85°C Industrial grade
22 Working humidity 10%-90% Relative humidity, no condensation
23 Storage temperature -40~+125°C ---