Condition: 100% Brand New
Item Type: Dental Sandblasting Machine
Connect type: 4-hole handpiece tube
Ambient Temperature: 5°C~40°C
Relative Humidity: ≤80%
Atmospheric Pressure: 86Kpa~400Kpa
Operating Water Pressure: 200Kpa~400Kpa
Working Pressure: 300Kpa~600Kpa
The water spraying amount of the working head should be greater than or equal to 30mL/min
Sandblasting amount of working head shall be greater than or equal to 2.0g/min
Air Pressure:
1. In the available range of 3-6kg, adjust by pressure switches on the processing machine.
2. Foot switches control for tooth cleaning and sandblasting machine to stop working from the beginning.
Water Pressure:
The pressure can exceed 0.5KG
Instructions:
1. Sandblast pot and cover:
A) Open the lid, pour the sandblasting powder below the green line (no more than 1/3 of the height of the jar), and then tighten the lid
B) Do not over-spray the powder at the height of 1/2 can to avoid clogging
C) Note that the cover with filter should not be deformed inside
2. Drainage button (drainage) : press the button three times before each use to discharge gas and powder of filter cup and desiccant.
3. Quantity of powder knob (air value) : adjust clockwise
4. Water knob (water level value) : adjust according to the actual work needs
5. Jet switches:
A) Spray powder from the foot switches ejected from the nozzle handle according to the spray switches in the "ON" position;"Off" to turn off the jet switches
B) After each use, pull the spray switches to the "OFF" position and step on the foot switches several times to remove more pipe than powder so as not to block the following time
6. Main connector: four hole connector connected to the main machine with high or low discharge screw