inside the handle is with low power dissipation and high voltage output, makes this flocking machine quite b flocking capacity. Specially design for flocking in small area, sand table construction model, and other DIY scenes. You can have a try. Using Steps: Charge the battery before using and check if the wire inside the machine is in contact with the wire mesh. Put in the grasspowder. It has been suggested that the length of the grasspowder is more than 5 mm, which is more effective. Then tighten the lid. On the target model and on the table, pull out the whitelatex and spread it evenly, ready to starts dusting with grasspowder. Touching the target surface of the platform with the negative electrical connector as close as possible, then use the seeder grass to starts spraying the grasspowder 20-30mm away from the platform target. After the grass dust is completed, pour the grasspowder or powder-supplement and blot it with a vacuum cleaner model. Cut the haystack with small-scissors and a toothpick until it grows evenly. Note: Do not use the negative terminal to contact them with the wire mesh, there is a danger caused by sparks! Use limit of less than 16 years old! Remove the battery and place it high when not in use. Static grass applicator is suitable for 3-5mm staticgrass. Powered by 2 * AA battery, you should prepare it by yourself. Specifications: Name: Static Grass Flocking Applicator Set Material: ABS Battery: 2 * AA battery (excluded) Rated working voltage: DC3V Rated working power: 0.15W Rated output voltage: ≥DC3000V Rated working current: 50mA Package size: 320 * 120 * 120mm / 12.60 * 4.72 * 4.72in Package weight: 365g / 12.87ounce Packing List: 1 * Brush 4 * Bags of Static Grass 1 * Static Grass Applicator 1 * Guideline